Picker machine for cuttings BRP\OR

Picker machine for cuttings BRP\OR

This cutting picker is suitable for picking up strawberry cuttings on the straw between mother plants standing on a (plastic-covered) back.

Operating procedure

The disc coulters at the front of the machine cut the tendrils loose from the mother plants. The protruding pins on the screening belt pick up the tendrils from the ground and transport them upwards. At the top, the pins drop out of the sieving belt so that the tendrils are not taken back with them. The plants land via the side discharge conveyor on the neighbouring wagon. The height is adjusted by the tractor's lifting device. The steerable rear axle allows short manoeuvres at the headland. Everything is controlled by a push-button box in the tractor.

General specifications

Passage under the side conveyer belt2.5 metres
Working speed2.5 km per hour


  • 3-point jack with K80 ball
  • Additional disc courier
  • Additional speed controller for the side discharge conveyor
  • Hydraulically height-adjustable drawbar
  • Hydraulically length-adjustable drawbar
  • Plants lifter in front of the pick-up

Common configurations


Rodebreite1350 mm
Track width1600 mm
Weight3500 Kg
LinkageK80 ball
Power requirement90 hp
Hydraulics1 (single-acting) pilot valve, 20 l/min &
1 (single-acting) pilot valve, 40 l/min
Electrical connection3-pin 12 VDC connector (ISO 12369) &
7-pin lighting plug (ISO 1724)